問題: How to check the RAID configuration via the Intel RST application under Windows 11?(12/15/2021) 回答: Please refer to the following steps to check the RAID configuration.
Step 1: Obtain the Intel(R) RST driver installation package and run the executable (SetupRST.exe). *RST driver can be obtained via the download section of the product page on the ASRock website. *Default settings and name of the driver may vary and is subject to change without notice.
Step 2: Install using the default setting and reboot the computer.
Step 3: From Windows desktop, find and launch the Intel® Optane(TM) Memory and Storage Management application.
問題: Why does the ASRock Timing Configurator show strange values, and how can I use this OC software under Windows 11? (10/1/2021) 回答: Microsoft® Windows 11® has a security function called "Memory integrity”. This function can prevent attacks from inserting malicious code into high-security processes, but it will interfere with the ability to read sensor values and affect the function of OC software.
We recommend temporarily disabling this function when you would like to use OC software. Please refer to the following steps to deactivate it.
Step.2 Press "Core isolation details”.
Step.3 Disable "Memory integrity” and restart the system to apply the setting.
問題: I cannot adjust the equalizer settings in the Nahimic3 utility ver:1.4.15. Where can I find the settings?(2/1/2021) 回答: To use the equalizer in the Nahimic3 utility, please refer to the following steps to activate it.
Step 1. Download and install Nahimic3 utility ver:1.4.15 from the ASRock website.
問題: I cannot control the RGB lighting via RAZER Synapse on my X570/B550 Taichi Razer Edition motherboard. How do I solve this problem?(1/1/2021) 回答: Please flash the RGB controller firmware by following the steps below.
Step 1. Download the firmware file from ASRock website and extract the compressed file.
Step 2. Execute "UpdateFW.cmd” to update the RGB controller firmware.
Step 3. After step 2 please wait for 10 seconds or so and the firmware flash will finish.
Step 4. After the message "update firmware SUCCESS” is shown please restart your system.